Tie-down 86105 User Manual download pdf

082212,a298

Boat Guides

Assembly Instructions

Part # 86105

This kit contains the following components:

Part # Description Qty.

#1 Guide Base 2

#2 Angle Adjuster 2

#3 Link Bar 2

#4 U-Bolt 2

#5 Carriage Bolt 3/8" x 3" 2

#6 Flat Washer 3/8" 2

#7 3/8" Hex. Nyloc Nut 2

#8 1/2" Hex Nyloc Nut 4

#9 Guide Tube 2

#10 Bullet End Cap 2

#11 1/2" Hex Nuts 2

Installing your Boat Guides:

1. Determine the position for the guides on your trailer.

(Side Guides are normally installed as far back as

possible on the trailer).

2. Place U-Bolt over frame. Determine the hole in Angle

Adjuster that most closely ﬁts your frame width.

3. Slide Angle Adjuster over inside leg of U-Bolt.

NOTE: For frames less than 3" wide and more

than 3" deep, thread 1/2" nut onto U-bolt ﬁrst.

4. Position the Guide Base under the frame so that the

u-bolt lines up in the slot on the Guide Base.

5. Loosely fasten the 1/2” nyloc nuts to the u-bolt.

6. Place the guide tube in position with the guide

base. Align the holes.

7. Place the 3/8”x 3” carriage bolt thru the guide base

and the guide tube, place 3/8” washer and nut on the

carriage bolt and tighten.

8. Repeat 1-7 for the other side.

9. Finally check the placement of both boat guides,

adjust position so they are both the same distance

from the end.

10. Tighten nuts under the guide base.

Instruction Sheet #15307

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com (404) 344-0000 Fax (404) 349-0401

Boat Guides 1

Summary of Contents

Page 1 - Boat Guides

082212,a298Boat GuidesAssembly InstructionsPart # 86105This kit contains the following components: Part # Description Qty. #1 Guide Base 2 #2

Comments to this Manuals

No comments

Tie-down 86105 User Manual

Browse online or download User Manual for Hardware Tie-down 86105. Tie Down 86105 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Tie-down 86105